“APPROVED”
Fatekh Vergasov
Owner-Builder
470 Ruthven Ave.,
Palo Alto, CA 94301-1222
From:
dan fulga [mailto:dnj.fulga@verizon.net]
Sent: Friday,
March 25, 2011 12:30 PM
To:
dnj.fulga@verizon.net; 'Fatekh Vergasov'
Subject: RE:
FulgaElectricalBid_1.doc
Fatekh,
Please reply back with “APPROVED” – acknowledging that you are now
in contract, and it’s your final decision.
Thanks,
Dan
Electrical $19,000 (to include CAT6 communication)
All job should conform latest NEC got into power from January 01,
2011
Item#1: Complete electrical wiring per drawing submitted dated
9/24/2010
Item#2: The following material are included in the bid:
All rough in materials for (boxes, wires, main panel, breakers,
outlets, switches and dimmers locations)
Provide rough and installation 200 Amps 120/240 volts MAINPANEL – as
small as possible: Meter + main breaker only
Provide rough and installation 125 Amps 120/240 volts SUBPANEL –
Subpanels should be three: 1st and 2nd floor + Garage
Provide rough and installation 50 Amps 120/240 outlet for oven.
Provide rough and installation 30 Amps 120/240 volts outlet for
dryer .
Provide rough and installation 30 Amps 120/240 volts disconnected
switch for A/C – Should be 40-50amps
Provide rough and installation 20 Amps 120 volts circuit for washer.
Provide rough and installation 20 Amps 120 volts circuit for garbage
disposal.
Provide rough and installation 20 Amps 120 volts circuit for hood.
Provide rough and installation 20 Amps 120 volts circuit for Mic. –
for Miscellaneous
Provide rough and installation 20 Amps 120 volts circuit for
furnace.
Provide rough and installation 20 Amps 120 volts circuit for top.
(67) Provide rough and installation 20 Amps 120 volts receptacle for
general proposes.
(18)Provide rough and installation 20 Amps 120 volts GFCI receptacle
in inside wet area.
(10)Provide rough and installation 20 Amps 120 volts GFCI receptacle
with water proof cover for outside area.
Lighting: provide rough and installation
Note: all switches for incandescent lighting will be installed in
dimmer per plan.
(35) provide rough and installation recessed light with white
baffle trim and light bulbs.
(13) provide rough and installation recessed fluorescent with baffle
trims and light bulbs.
(5) provide rough and installation exhaust fan + light combination
“Panasonic” less 1 son
(7) provide rough and installation smoke detector with battery
back-up.
(4) provide rough and installation switch leg for ceiling mounted
lighting fixtures.
(6) provide rough and installation under cabinet fluorescent light.
(11) provide rough and installation switch leg for wall mounted
scones lighting fixtures.
Phone and cable: provide and installation
Provide and installation low voltage exterior box.
(7) provide rough and installation cable outlets.
(7) CAT-6 rough and installation
(5) provide rough and installation phone outlets.
Note: owner should furnished and provide all hanging fixtures,
interiors wall mounted, exterior wall mounted lighting fixtures and
installation by electrical contractor.
Note 1: This bid does not include the overhead line from pole to the
main panel
Note 2: This bid does not include any trenching or conduits between
buildings or from the street/pole
Note 3: This bid does not include permit
Note 4: This bid does include any wall / roof or stucco repair if
required, but only those, which are caused by electrical contractor
Note 5: All jobs, materials and services not directly assigned to
the owner or not mentioned in this bid are 100% Electrician
responsibility
Dan Fulga
21900 Old Santa Cruz Hwy
Los Gatos, CA 95033
Lic#938344